Lutron RadioRA2 300W Lamp Dimmer (snow white)

Name: Lutron RadioRA2 300W Lamp Dimmer (snow white)
SKU: RRD-3LD-SW
Availability: InStock

MSRP: $188.00

Manufacturer: Lutron

SKU: RRD-3LD-SW

Function much like standard lamp dimmers, but can be controlled as part of a lighting control system. Lamp Dimmers are useful in locations where plug-in lamps need to be dimmed or non-dimmable lighting loads need to be switched
Incorporate advanced features such as fade on / fade off, delayed long fade off and rapid full on
Simple to install and easy to use – allow floor and table lamps to be added to a system quickly and easily
On a single-tap, lights fade ON or OFF
On a double-tap, lights go to full ON
When ON, press and hold to engage the delayed long fade to OFF
Light levels can be fine-tuned by pressing and holding the dimming rocker until the desired light level is reached
Power: 120V ~ 50/60Hz
Typical power consumption: 0.25 W (Test conditions: load is off and nightlight mode enabled)

Power	120 V ~ 50 / 60 Hz
Typical Power Consumption	0.25 W Test conditions: load is off and nightlight mode enabled.
Regulatory Approvals	UL, CSA, NOM, FCC, IC, COFETEL
Environment	Ambient operating temperature: 32 °F to 104 °F (0 °C to 40 °C), 0% to 90% humidity, non-condensing. Indoor use only.
Communications	Lamp Dimmers communicate with the system through Radio Frequency (RF) and must be located within 30 ft (9 m) of a repeater. System devices operate on frequencies between 431.0 MHz and 437.0 MHz.
ESD Protection	Tested to withstand electrostatic discharge without damage or memory loss, in accordance with IEC 61000-4-2.
Surge Protection	Tested to withstand surge voltages without damage or loss of operation, in accordance with IEEE C62.41-1991 Recommended Practice on Surge Voltages in Low-Voltage AC Power Circuits.
Power Failure	Power failure memory: should power be interrupted, the Lamp Dimmer will return to its previous state when power is restored.
Load Type	Incandescent, Halogen: 10W-300W MLV: 10W/VA-200W/300VA CFL, Fluorescent, ELV (Switching Mode Only): 10W-300W

HxDxW	3.75" x 0.9375"/0.6875" x 2.4375"
Cord Length	6'

Product Files

SPEC SHEETS

Function much like standard lamp dimmers, but can be controlled as part of a lighting control system. Lamp Dimmers are useful in locations where plug-in lamps need to be dimmed or non-dimmable lighting loads need to be switched
Incorporate advanced features such as fade on / fade off, delayed long fade off and rapid full on
Simple to install and easy to use – allow floor and table lamps to be added to a system quickly and easily
On a single-tap, lights fade ON or OFF
On a double-tap, lights go to full ON
When ON, press and hold to engage the delayed long fade to OFF
Light levels can be fine-tuned by pressing and holding the dimming rocker until the desired light level is reached
Power: 120V ~ 50/60Hz
Typical power consumption: 0.25 W (Test conditions: load is off and nightlight mode enabled)